LOCATION:HOME > PRODUCT CENTER > PoE Switches > L2 Managed Switches > SG2526P

SG2526P

SG2526P is a smart PoE switch independently designed by TG. Featured with 24 IEEE 802.3at/af-compliant RJ45 ports, it supplies a maximum PoE power output of 370 W. The switch can supply power when transmitting data with APs, IP cameras, and IP phones through CAT5 cables . Featured smart management functions, POE intelligent detection, 802.1Q VLAN, link aggregation, QoS and MAC address binding, it minimizes the difficulty and cost in networking deployment.
MORE+
Share:
■  Provide -48V DC power for powered devices (PDs), such as IP Phones, WLAN APs, and Bluetooth APs.
■  Compatible with both IEEE802.3at(30W) and IEEE802.3af(15.4W), can supply power to PDs under these two standards;
■  Transmitting electronic power together with data through a single network cable, free of power lines;
■  Automatically detect and supply power to IEEE802.3at and IEEE 802.3af compliant powered devices(PDs);
■  Advanced SAFC function, only supply power to IEEE 802.3af/at compliant PDs, no worry about damaging other private standard PoE devices or devices without PoE function;
■  Support port power supply prioritization, guarantee the continuous power supply of key nodes;
■  Up to 100m network cable transmitting distance, support flexible network expansion without power line deployment concerns. Users can freely fix their wireless APs, IP cameras or other end devices on the wall or ceiling;
■  Built-in PSE power supply module, plug-and play design, easy to install;
■  High security performance defending against power surge;
■  Support short-circuit protection function, the switch will automatically start short-circuit function and cut off the power supply when there is high-current or other power failures, which can efficiently defend against device damage or network failures caused by line fault or wrong installation;
■  Energy-saving green design, support auto-switch to standby mode and auto-detect cable length. It will stay in standby mode and save the power when the port is disconnected , or provide a lower transmission power when the network cable is less than 10m;
■  Support CLI Management ,SNMP Management, simple WEB management, easy to configure the functions of switches.

■  PoE schedule to save power.
■  Intelligent restart, schedule reset per PoE Port to maintain your IP Cameras,APs and other devices.

Product Information
Product Model SG2526P
Hardware specifications
Fixed Ports 24*10/100/1000 Base-T ports(POE/POE+)
2* 1000 Base-X SFP ports
Consloe 1
Reset 1
Max Output Power(single port) 30W
Total Power Consumption 440W
PoE Pin-out 1/2(+),3/6(-)
Switching capacity 52Gbps 
Forwarding Rate 39Mpps
Flash/RAM 16MB/128MB
Temperature Operating temperature: (-10 - 50)°C
Storage temperature: (-40 - 70)°C
Humidity Operating humidity: (10% - 90%) RH, non-condensing
Storage humidity: (5% - 90%) % RH, non-condensing
Dimensions(L*W*H) 440(L)*285(W)*44.5(H)mm
Power AC:100~240VAC,50~60Hz
Power consumption 440W output the whole device
Weight <6Kg
Lightning protection 6KV
MAC address table 8K
LED Indicator Power,System ,Link/Act,POE

Software specifications
Forwarding mode Store-and-forward
Protocol and Standards IEEE 802.3, 10 Base-T Ethernet;
IEEE 802.3u,100 BASE-TX;
IEEE 802.3ab,1000 BASE-T;
IEEE 802.3z,1000 BASE-X;
IEEE 802.3az,EEE(Energy Efficient Ethernet);
IEEE 802.3af
IEEE 802.3at
MAC Address Table Up to 8K MAC addresses
Support auto-update, two-way learning
Buffer Memory 4.1Mbit
Jumbo Frame 9K Bytes
VLAN Port-based VLANs
4K-entry Vlan Table
VLANs based on IEEE 802.1q
Spanning Tree Support Spanning Tree Protocol
Support Rapid Spanning Tree Protocol
Link Aggregation Support 8 aggregation groups, and a maximum of 8 ports in each aggregation group
Static aggregation and LACP
Port Mirroring Support bi-direction port mirroring
RSPAN function for remote mirroring
Port Isolation Isolation between downlink ports without influence the communication between downlink and uplink ports
Port Flow Control Back-pressure traffic control under Half-Duplex mode
IEEE 802.3x traffic control under Full-Duplex mode
Port Rate Restriction Port-based ingress or egress rate limiting
DHCP DHCP Snooping
IPv6 ICMP v6, Telnet v6
Storm Suppression Support the suppression of broadcast storm based on forwarding rate
Multicast Control Support IGMPv1/2/3 and MLDv1/2 Snooping;
Security Attack Prevention(Land attack\Blat attck\Ping attack\TCP control flag attrck)
MAC & Port based Security
QOS 802.1p(Port Queuing Priority)
WRR (Weighted Round Robin)
Cos/Tos,QOS
PoE PoE ouput priority Management
Intelligent restart
Timed restart
Physic Medium 10/100Base-TX:UTP category 3/4/5 cables( Maximum 100m)
1000Base-T:UTP Category 5 cable( Maximum 100m)
1000Base-SX:fiber with 850nm wavelength,supports a max transmission distance of 550m
1000Base-LX:fiber with 1310nm / 1550nm wavelength,supports a max transmission distance of 80km
Network Cable Deployment Support Auto-MDIX function, automatically identify straight forward cable and cross-over cable
Negotiation Pattern Support port auto-negotiation function( automatically negotiate transmission rate and Duplex modes)
Maintenance Detect the connectivity of network cables
Uploading or downloading of the configuration data
Uploading of upgrade patch
Support system logs
WEB-based reset to factory defaults
Management WEB-based management
CLI Management (Command Line Interface)
Telnet
SNMP

Product Information Detailed information
SG2526P 24*10/100/1000 Base-T ports(POE/POE+), 2* 1000 Base-X SFP ports, IEEE 802.3af/at,Total Output Power: 440W.
Transceivers
SFP-GE-SX-MM850 1000BASE-SX SFP Transceiver, Multi-Mode (850nm, 550m, LC)
SFP-GE-LX-SM1310 1000BASE-LX SFP Transceiver, Single Mode (1310nm, 20km, LC)
SFP-GE-SC-1310 SFP Gigabit optical module, TX1310/RX1550 (20km, SC)
SFP-GE-SC-1550 SFP Gigabit optical module, TX1550/RX1310 (20km, SC)

TOP